Speedflow 10L Unvented Water Heater 2 kW

Ideal for use in cloakrooms and kitchens in offices, shops, student accommodation and domestic premises which have been extended and there is no central hot water system near by. One unit located under the kitchen sink is often used to supply hot water for light dish washing in the kitchen sink and hand washing in the cloakroom basin.

Features

• Supplies hot water for up to 3 basins
  • Can be used with regular taps including mixers
  • Mains pressure flow rates
  • 2.0 kW element as standard
  • Neon element on indicator
  • Glass lined steel tank as standard
  • External temperature control with frost protection setting

Outer Casing
Easy clean, high impact plastic

Heating Element
Stainless steel flange type

Thermostat
Bulb type adj. to 75°C
E setting approx. 50°C

Water Tank
Glass lined steel

Anode
Replaceable grey magnesium (inspect at least annually or more regularly in scale/ aggressive water conditions)

Insulation
High density polyurethane foam

Safety
Overheat temperature protection (manual reset).
Supplied pressure relief valve must be fitted in every case (set at 6 bar).
Frost protection if power on.
Optional thermostatic mixing valve to maintain hot water supplied to user at constant, safe temperature.

IP Rating
IPX4

Installation
Site above or below the sink, but inlet and outlet must be at the top.

Floor standing or wall mounted.

Plumbing
Must be installed by a suitably qualified person.

Access to the thermal cut-out and element is located at the base of unit.

Minimum water pressure 0.5 bar.
Maximum water pressure 4.2 bar.

Water connection
Inlet/ Outlet 2 x 1/2″ BSP male (100mm apart centre to centre).
Fittings required (not supplied): 2 x 15mm compression to 1/2″ BSP female adapter.

Electrical Connection
Installation must comply with current IEE regulations.

The product should be connected to the fixed wiring of the property via a double pole fused spur with a minimum break capacity of 13 amps.

Cable pre-wired (1.5m).

Approvals
CE, UKCA, WRAS

Standard Warranty
2 year parts or replacement warranty.

The Energy Related Products (ErP) Directive and Energy Labelling Directive require that from September 2015 all water heaters in scope meet minimum energy performance criteria and have energy labels which provide the energy ration of the product. The classifications range from A++; this being the most efficient and coded in green to a rating of G; this being less efficient and coded in red.

Such ratings provide transparency of efficiency and a comparable benchmark for water heating products, as standardised European Energy Labels are used.

This website contains the energy class for all relevant water heating products. The full energy label and product fiche information for the Speedflow range can be found below